aaptekgsm
A M C T

aaptekgsm

A K M P T A
 
HomeTop poserRegisterLog in

Attention : amct team is a subsiediary of A.K.M.P.T.A


Share | 
 

 Modify Processor And Memory Voltage

View previous topic View next topic Go down 
AuthorMessage
Justin_Romile
GOOD POSTER
GOOD POSTER
avatar

Male
Age : 23
Job/hobbies : Computer Stuffs & Playing Guitar

PostSubject: Modify Processor And Memory Voltage   Sat May 14, 2011 12:40 pm

[Caution! Incautious modification of CPU and memory voltage can easily damage your components.]

If you have reached the upper limit of your PC's stock overclocking potential, consider bumping up the voltage delivered to the processor and/or the memory. By increasing the amount of voltage available to these components, you can increase their overclocked stability. Unfortunately increasing the voltage also increases the heat produced, especially in the case of the processor.

While increasing the voltage slightly generally results in a better overclock, increasing the voltage too much will simply result in a locked-up PC due to overheating, or burnt out circuits. Definitely a case of diminishing returns, unless you invest in a better cooling solution (which is beyond the scope of this article).

Be sure to increase voltage only in single increments. Once you have increased CPU voltage, experiment with overclocking the CPU and FSB again to see if you can push the system farther. It is unlikely that you will see much benefit past one or two voltage increments, especially with a stock heatsink.
Back to top Go down
http://viostech.forumotion.com/
 
Modify Processor And Memory Voltage
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» ST 70 Quad Cap (Long Post)
» Mk II ... Mk III
» Low Rectifier Voltage output after SDS Cap board install.
» ST70 Voltage Chart
» high voltage on speaker terminals of Mk4?...

Permissions in this forum:You cannot reply to topics in this forum
aaptekgsm :: === COMPUTER SECTION === :: === PC HARDWARE ===-
Jump to: